Home › Furnace filters › 59MN7B
The Carrier 59MN7B modulating gas furnace uses one of 3 filter sizes, depending on cabinet width (or model) and return location: 16x25x3/4, 20x25x3/4, 24x25x3/4 (per the Carrier document cited on this page). The page's table shows which size applies to each cabinet and return.
Verified from manufacturer doc Modulating condensing 4-way multipoise gas furnace
| Casing width | Side return | Bottom return |
|---|---|---|
| 17-1/2 in. | 16 x 25 x 3/4 | 16 x 25 x 3/4 |
| 21 in. | 16 x 25 x 3/4 | 20 x 25 x 3/4 |
| 24-1/2 in. | 16 x 25 x 3/4 | 24 x 25 x 3/4 |
Filter cabinet: (1) 16/20/24 x 25 x 3/4 washable or (1) 16/20/24 x 25 x 4-5/16 media.
General guidance (not from this manual): check monthly and replace 1-in. filters every 1–3 months, or follow the filter maker's guidance and your owner's manual.
Pull the old filter and read the size printed on its frame. Nominal sizes are rounded up: a 15.5 x 24.5 in. filter is sold as 16 x 25.
Your furnace manual lists the filter's dimensions, not its MERV rating. Higher-MERV filters restrict more air. Manufacturers such as Carrier recommend keeping the clean-filter pressure drop under 0.2 in. w.c. (ideally under 0.1). Lennox warns that an over-restrictive filter can trip the high limit in winter and freeze the coil in summer. If you want MERV 11–13, a 4-in. media cabinet is the usual route. Ask an HVAC tech to check static pressure. Nominal sizes are rounded: a filter labeled 16 x 25 x 1 actually measures about 15.5 x 24.5 x 0.75.
Installation Instructions 59MN7B-02SI, filter sizing tables
Last checked 2026-10-21. Manufacturers revise documents. If your unit's label disagrees, trust the label.
The Carrier 59MN7B modulating gas furnace uses one of 3 filter sizes, depending on cabinet width (or model) and return location: 16x25x3/4, 20x25x3/4, 24x25x3/4 (per the Carrier document cited on this page). The page's table shows which size applies to each cabinet and return. 17-1/2 in. – 16 x 25 x 3/4 – 16 x 25 x 3/4; 21 in. – 16 x 25 x 3/4 – 20 x 25 x 3/4; 24-1/2 in. – 16 x 25 x 3/4 – 24 x 25 x 3/4.
General guidance (not from this manual): check monthly and replace 1-in. filters every 1–3 months, or follow the filter maker's guidance and your owner's manual.
Filter sizes are nominal (rounded). A filter sold as 16 x 25 x 1 actually measures about 15.5 x 24.5 x 0.75 in. Buy by the nominal size printed on the frame.
Installation Instructions 59MN7B-02SI, filter sizing tables (https://www.shareddocs.com/hvac/docs/1009/Public/0D/59MN7B-02SI.pdf), last checked 2026-10-21.